How to programme a burner to switch off
for about 3 seconds. controls (see par.�How
To programme a burner to switch off, proceed as follows: 1. If necessary, activate the hob by touching the main ON/ OFF Control 2. Light the burner and adjust the flame level using the Increasing or Decreasing to light a burner�).
3. Activate the Timer by touching the Timer Control and select the required burner by repeatedly touching the Timer Control .
4. Set the required cooking time touching the Increasing and Decreasing Controls. (max. time: 99 minutes). Once the cooking time has been set, the burner selection can no longer be changed. If you want to change burner, you must set the cooking time to zero by means of the Decreasing control, and then change the burner selection by touching the Timer Control . 5. The timerstarts the countdown a few seconds after the cooking time has been set. 6. During the last ten seconds, the timer starts beeping to advise that the cooking time is about to end. 7. An acoustic signal sounds at the end of the cooking time. To stop the acoustic signal, touch the Timer Control To adjust the cooking time: 1. Touch the Increasing or Decreasing at any time to adjust the time setting. To cancel the time setting: 1. Touch the Decreasing time to zero. Control or .
Control to set the cooking
It is possible to programme the switch-off of ONLY ONLY one burner at a time. You can set the cooking time as well when the burner is already lit. For example, you can bring a pot of water to the boil, then put some vegetables, meat or pasta and programme the required time for their cooking. The residual heat indicators remain on even when the hob is off, until the burner and the pan supports have cooled down.
